Metastability

What is metastability: Literally speaking, metastable state refers to a state "which is not so much stable" and a slight disturbance will cause the system to lose state. In the context of VLSI, specifically sequential design, in addition to two stable states "0" and "1", there is also a state in-between at which the output may wander for some time due to inherent feedback design of a latch. This state is known as meta-stable state and the phenomenon is known as metastability. In order to understand this, let us study two back-to-back connected inverters as shown in figure below.

Figure 1: Inverter loop schematic


When the output (N2) of top inverter is 1, M4 & M1 are on. Simlilary, when output is 0, M3 & M2 are on. If the voltage of output inverter is left at anything other than VDD or GND, M4 and M1 try to pull the output towards 1 and the other two pull it towards 0. The final settlement value (either 0 or 1) is dependent upon whose initial pull is stronger. However, if the initial pull combined of M4 & M1 is equal to M3 & M1, the output will not move. The output may or may not remain at this level for some time until equilibrium is maintained. However, if forcefully, we change the output by even a small value, it will settle at 0 or 1 depending upon the direction of forced change. This state is the so-called metastable state. The inverter pair can remain in this state as long as there is no disturbance in the voltage levels. This disturbance can be due to external factors such as external forced voltage or internal factors such as crosstalk. So, if it is left to come out of metastability by itself, the time to come out of metastability is unknown. It depends upon:

  • The value of voltage stimulus: If the level of disturbance is greater than a certain threshold, the output will start to move towards one of the stable levels. Of course, larger the value of initial disturbance, faster will be time to stability
  • Strengths of inverters to pull towards "0" and "1": The less voltage resolution capability the inverter pair has, it will be able to come of metastability in shorter time

No comments:

Post a Comment

Thanks for your valuable inputs/feedbacks. :-)

Subscribe to: Post Comments (Atom)