How can we generate a pulse for every edge of the incoming pulse

It is a very common requirement to detect either positive edge, negative edge or both edges of a signal. And the circuit that can detect and generate a single cycle pulse is quite simple. In this post, we will discuss how we can detect positive edge, negative edge and both edges of a signal.

• Detect positive edge of a signal: Positive edge of a signal means that the current state of the signal is "1" and previous state is "0". And a pulse signal means that the output of the circuit is "1" for one cycle. So, we need a circuit which generates "1" as output when present state is "1" and previous state is "0". It generates "0" as output otherwise.

Thus, output = D(n-2)' & D(n-1)

The required implementation is shown in figure 1 below:

Figure 1: Detection of positive edge of signal

• Detect negative edge of a signal: Negative edge of signal means that the current state of the signal is "0" and previous state is "0". So, we need a circuit which generates "1" as output when present state is "0" and previous state is "1". It generates "0" as output otherwise. 

Thus, Neg_edge_detect = D(n-2) & D(n-1)'

 The required implementation is shown in figure 2 below:

Figure 2: Detection of negative edge of signal

• Detecting both positive and negative edges of the signal: Simply doing an "OR" operation of Pos_edge_detect and Neg_edge_detect signal will produce an output which is a single cycle pulse for any of the edge of incoming signal. The requirement for consecutive edges of incoming signal is to be at least 2 cycles apart otherwise, the output will not be pulse, but will be a continuous signal.

Any_edge_detect = Pos_edge_detect + Neg_edge_detect

The required implementation is shown in figure 3 below:

Figure 3: Detection of both positive and negative edges of signal

The technique we discussed here delays the output by two cycles. Can you think of any other way to detect the edges of a signal which is more efficient?