What is Static Timing Analysis?

Static timing analysis (STA) is an analysis method of computing the max/min delay values of a complete circuit without actually simulating the full circuit. In STA, static delays such as gate delay and net delays are considered in each path. These delays are, then, compared against the required bounds on the delay values and/or the relationship between the delays of different gates. In STA, the circuit to be analyzed is broken down into timing paths consisting of gates, registers and nets connecting these. Normally, timing paths start from and end at registers or chip boundary. Based on origin and termination of data, timing paths can be categorized into four categories:

        1.)    Input to register paths: These paths start at chip boundary from input ports and end at registers

        2.)    Register to register paths: These paths start at register output pin and terminate at register input   pin

        3.)    Register to output paths: These paths start at a register and end at chip boundary output ports

        4.)    Input to output paths: These paths start from chip boundary at input port and end at chip               boundary at output port

Timing path from each start-point to end-point are constrained to have maximum and minimum delays. For example, for register to register paths, each path can take maximum of one clock cycle (minus input/output delay in case of input/output to register paths). The minimum delay of a path is governed by hold timing requirement of the endpoints. Thus, the maximum delay taken by a timing path governs the maximum frequency of operation.

As stated before, Static timing analysis does timing analysis without actually simulating the circuit. The delays of cells are picked from respecting technology libraries. The delays are available in libraries in tabulated form on the basis of input transition and output load, which have been calculated based by simulating the cells for a range of boundary conditions. Net delays are calculated based upon R and C models.

One important characteristic of static timing analysis that must be discussed is that static timing analysis checks the static delay requirements of the circuit without applying any vectors, hence, the delays calculated are the maximum and minimum bounds of the delays that will occur in real application scenarios with vectors applied. This enables the static timing analysis to be fast and inclusive of all the boundary conditions. Dynamic timing analysis, on the contrary, applies input vectors, so is very slow. It is necessary to certify the functionality of the design. Thus, static timing analysis guarantees the timing of the design whereas dynamic timing analysis guarantees functionality for real application specific input vectors.

I hope you’ve found this post useful. Let me know what you think in the comments. I’d love to hear from you all.